Remington 60QT Trail Box: Secure Gear Storage for Truck Beds
By IRIS USA | Published: 2026-11-03
Category: How-to Guides
Learn how to load, secure, and care for the Remington 60QT Trail Box in a truck bed. A practical guide for camping gear, tools, and weather-resistant storage.
Quick answer
Use the Remington 60QT Trail Box as a dedicated truck bed storage container for camping gear, tools, and other bulky items. Load it evenly, secure it with straps, and check the lid seal before every trip to keep contents dry and protected.
Why the 60QT size works for truck beds
At 60 quarts (15 gallons), this heavy duty storage box for truck bed use offers a practical balance: large enough for a weekend's camping gear or a set of power tools, yet compact enough to leave room for other cargo. The stackable design also helps when the box is off the truck, letting you store it efficiently in a garage or closet.
The Remington Trail Box is built for rugged environments, but no box is invincible. It is weather resistant, not waterproof, so avoid leaving it exposed to driving rain for extended periods. For most truck bed storage container needs—hauling gear to a trailhead or keeping supplies organized—it performs well.
When to choose a different container
If you routinely carry very heavy, sharp, or oversized items that could puncture the lid or walls, a metal job-site box may be more appropriate. Similarly, if you need fully submersible waterproofing, look for a gasket-sealed case. The Remington 60QT Trail Box shines for general gear storage where easy access and stackability matter more than extreme protection.
How to load and secure the Trail Box in your truck bed
- Position the box for weight distribution: Place the Trail Box over or slightly ahead of the rear axle, centered side-to-side. This keeps the weight balanced and reduces bouncing. Common mistake: putting it at the very back, which can make the truck feel light in the front and cause the box to slide. Check that the box sits flat and does not rock before loading.
- Load heavy items first and fill gaps: Put dense gear like tools or cast-iron cookware at the bottom, then fill empty spaces with soft items like clothing or tarps to prevent shifting. Avoid leaving large air pockets. Checkpoint: shake the box gently—if contents rattle or slide, repack. Distribute weight evenly across the bottom for stable transport.
- Secure the lid and check the seal: Press the lid down firmly until it clicks or seats evenly. Run a finger along the seal to feel for debris or gaps. Common mistake: overstuffing so the lid cannot close fully, which compromises weather resistance. If the lid does not close easily, remove items until it does.
- Strap the box to the truck bed: Use two cam straps or ratchet straps over the top of the box, anchored to the truck bed tie-downs. Tighten until snug but not so tight that the lid deforms. Checkpoint: push the box side-to-side—it should not move more than an inch. Re-tighten straps after the first 10 miles of driving, as loads settle.
- Plan for weather and access: If rain is expected, angle the box so water runs off the lid, and avoid overloading so the lid seal stays effective. For camping gear, pack items you need first near the front or top for easy access. Common mistake: assuming the box is fully waterproof—use dry bags for sensitive electronics. Keep a small towel or desiccant pack inside if you store gear long-term.
Product facts
- Remington - 60QT / 15Gal Trail Heavy Duty Box: The Remington Trail Box Heavy Duty Storage Series is designed for organizing, transporting, and safeguarding gear in any environment. This means you can use it confidently for truck bed storage, garage organization, or camping trips without worrying about basic wear.
Remington - 60QT / 15Gal Trail Heavy Duty Box - Remington - 60QT / 15Gal Trail Heavy Duty Box: The stackable design helps maximize storage space in closets, garages, basements, or other areas. When the box is not in your truck, you can stack it with other bins to save floor space.
